Measuring Guide


Inside Mount
Measuring Guide Inside Mount - Measure width across at inside top, middle, and bottom. Use the narrowest measurement for ordering. - The factory will take a 1/2” deduction (1/4” from each side) for operating clearance unless instructed otherwise.

- Measure height at inside top to bottom. No deductions are taken from length measurements. - Note:Finished shade length may not be exactly as specified if exact dimension falls in the middle of a wide slat. Length tolerance of +/- 1”*No bracket provided for IM, will included 2” screw for installation.


Outside Mount
-Measure exact finished width of shade. It is recommended that 3” be added to shade width for standard overlap.
-Measure exact finished length of shade. It is recommended that 1”~1 1/2” be added to the length for standard shade.

-No deductions are taken for outside mount measurements. -Side returns are not included.
-Note: Finished shade length may not be exactly as specified if exact dimension falls in the middle of a wide slat. Length tolerance of +/- 1”.
-Note: Valance width is equal to shade width

Ceiling Mount

-Indicate whether inside or outside mount and refer to above instructions.
-Note: Please use metal tape measure for all measurements Round all measurements to the nearest 1/8”.